Hi-Touch Imaging Technologies CS-300 User Manual download pdf (Page 7)

www.hi-ti.com

1-2 Appearance of CS-300

 CS-300 Front side

A. Card Input Hopper

This is the Card Input Hopper for storing blank cards. Please insert the blank

cards gently and remember to shield them with the built-in cover to avoid any

dust entering in there.

B. Card thickness selection button

HiTi CS-300 provides four selections for thickness: 0.3 mm (10 mil), 0.5 mm (20

mil), 0.8 mm (30 mil) and 1.0 mm (40 mil). Please move and slide the selector for

thickness to the correct thickness position, which matches the thickness of the

cards in the Card Input Hopper.

C. LCD Display:

The status of the printer is displayed on the LCD screen, you can use [◄], [►],

[OK], [ESC] buttons to control the operation of the printer and for

troubleshooting.

D. ID Button

To replace ribbon cartridges, please gently slide the ID button on the top of the

printer to open the ribbon door.

E. Rejected box

When an error occurs during the reading/writing process for smart chips and/or

magnetic cards, these cards are ejected into a rejected box, which holds about

20 cards. The system will show an error message when cards accumulate to

around 20 pieces in the rejected box. Please remove these cards to continue the

printing task.

F. Card Output Hopper

The printed cards will be placed here.

1 2 3 4 5 6 7 8 9 10 11 12 ... 55 56

No comments

Hi-Touch Imaging Technologies CS-300 User Manual Page 7